Before ordering replacement parts or starting your repair, review the factory torque specifications, required tools, and critical vehicle gotchas below.
Factory Specifications & Torque Ratings
Component / Parameter
Factory Specification
DIY Relevance
Wheel Lug Nut Torque
150 ft-lbs (21mm or 22mm socket) - CRITICAL TRUCK SPEC
Torque in criss-cross pattern after wheel install
Repair Difficulty Rating
Easy to Moderate (30-60 minutes)
Based on average DIY home garage setup
Recommended Tools Checklist
Spark Plug Socket (5/8" or 14mm with rubber/magnetic insert)Safely grip and extract spark plugs
3/8" Drive Ratchet & Extensions (6"-10")Reach down deep spark plug wells
Torque Wrench (Inch-lbs or Low Ft-lbs)Ensure proper crush washer seal without stripping head
Dielectric GreaseCoat inside of ignition coil boot to prevent flashover
Step-by-Step DIY Summary
Access Coils: Remove the engine cosmetic cover. Disconnect the electrical connector for each ignition coil pack.
Remove Coils: Remove the coil pack retaining bolt (usually 8mm or 10mm) and pull the coil boot straight up with a slight twisting motion.
Extract Old Plugs: Lower the spark plug socket and extension into the tube. Break loose counter-clockwise and unscrew slowly. Inspect electrode color.
Install New Plugs: Check gap against vehicle spec (pre-gapped iridium plugs must not be aggressively bent). Hand-thread the new plug 4-5 full turns to prevent cross-threading.
Torque & Reassemble: Torque plugs to factory spec (typically 13–18 ft-lbs). Apply a dab of dielectric grease inside each coil boot, re-seat coils, tighten coil bolts, and reconnect harnesses.
More 2018 Ford F-150 DIY Guides & Price Comparisons
Working on other repairs for your F-150? Compare prices across major retailers for other common replacement parts:
Back to Search
CarParts.com
NAPA