Before ordering replacement parts or starting your repair, review the factory torque specifications, required tools, and critical vehicle gotchas below.
Factory Specifications & Torque Ratings
Component / Parameter
Factory Specification
DIY Relevance
Wheel Lug Nut Torque
150 ft-lbs (21mm or 22mm socket) - CRITICAL TRUCK SPEC
Torque in criss-cross pattern after wheel install
Repair Difficulty Rating
Easy (20-30 minutes)
Based on average DIY home garage setup
Recommended Tools Checklist
Oil Filter Wrench / Filter Socket CupLoosen spin-on filter or canister cap
Position Drain Pan: Slide drain pan directly underneath oil filter mounting location.
Remove Filter: Use filter wrench to loosen counter-clockwise. Once loose, spin off by hand and dump remaining oil into drain pan.
Inspect Mounting Surface: Wipe the engine filter mating flange with a clean rag. Verify the old rubber gasket did NOT stick to the engine.
Lubricate New O-Ring: Dip your clean finger in fresh engine oil and coat the rubber O-ring gasket of the new filter.
Install Hand-Tight: Spin the new filter on until the rubber gasket touches the engine flange. From that contact point, tighten an additional 3/4 turn BY HAND ONLY. Do not over-tighten with a wrench.
More 2015 Ford F-150 DIY Guides & Price Comparisons
Working on other repairs for your F-150? Compare prices across major retailers for other common replacement parts:
Back to Search
CarParts.com
NAPA