Before ordering replacement parts or starting your repair, review the factory torque specifications, required tools, and critical vehicle gotchas below.
Long Extension & Socket (10mm/13mm)Battery hold-down bracket clamp
Battery Terminal Wire Cleaning BrushScour lead terminals and cable clamps
Dielectric Grease or Anti-Corrosion SprayPrevent acidic crust buildup on terminals
Step-by-Step DIY Summary
Preparation: Turn off engine, headlights, and all electronics. Note vehicle radio codes if applicable.
Disconnect Cables: Loosen the negative (-) black cable clamp nut (usually 10mm) and twist off. Next, loosen and remove the positive (+) red cable clamp.
Remove Hold-Down: Unbolt the battery hold-down clamp or wedge bracket using a long extension socket.
Swap & Clean: Lift the heavy old battery out vertically. Clean the battery tray and wire-brush the interior of both cable clamps to bare, shiny metal.
Install & Connect: Drop in the new battery, secure the hold-down bracket, connect Positive (+) first, then Negative (-) last. Apply anti-corrosion spray or terminal grease.
More 2006 Jeep Wrangler DIY Guides & Price Comparisons
Working on other repairs for your Wrangler? Compare prices across major retailers for other common replacement parts:
Back to Search
CarParts.com
NAPA